Condenser Operation – Basic Steps to Follow For Better Understanding

condenser operation

Condenser Operation – Basic Steps to Follow For Better Understanding

If you are a homeowner, you must be aware of the details about the condenser operation in your home. If you are a person with knowledge about this operation, you will not face difficulties while operating the condenser. But if you do not have any idea about the basic operations, then it is not too difficult for you to manage this appliance. Just follow these few steps for the better understanding of the condenser operation in your home.

The first step is to decide what kind of condenser you want to install in your home. There are two types of condensers in the market- the refrigerant condenser and the water-to-air condenser. In both the two types, there is an evaporator coil that uses the air as a coolant to transfer heat from the surroundings to the water circulating inside the condenser. To remove heat from the water, it will pass the water through the coil. The power source for this type of condenser is electrical motor. But in the last ten years, the air-to-water condenser is used as the most preferred condenser among homeowners. It is available in wide range of sizes that fit the requirements of different kinds of home.

The second step is to make sure that the power supply that is powered by electricity should be checked. The condenser has a special circuit that connects it with the power supply. The condenser circuit can be divided into two parts: the condenser control panel and the condenser meter. The condenser control panel controls the condenser meter. The meter shows the measurement of the hot water output and storage capacity of the condenser. The condenser output can be changed using the condenser power switch. If the condenser is turned off, the condenser meter will show the value of the power supply and it will also show the water flow out of the condenser.

This entry was posted in Uncategorized. Bookmark the permalink.